Normally, this would display the HASP SRM Admin Control Center. Some posts said to try to go to this url in your browser: but that just displayed an error. Doing an Uninstall followed by a Scan for New Hardware did not help. I looked in the Device Manager and saw an error for the HASP device and its properties said the device driver was not installed. Searching on this error showed several hits saying to go to the windows Services and enabling the HASP License Manager (or Sentinel HASP License Manager) but in my case, I did not have the HASP entry in Services. I tried doing a repair install and also install of drivers (from the main install menu) – neither helped. At any point, running the program with the dongle installed resulted in the H0033 error. Two of the updates seemed to end with an error, perhaps because I did not reboot the PC after each (it was not clear whether or not to do this). Installation went through normal software install and then it also had 3 updates to install. The software is protected by requiring the user to have a USB dongle plugged in when running the program. My wife asked me to install her Viking embroidery “5D” software on her Surface Pro PC so she could use the touch tablet and pen to do graphics drawing and editing in the Design Creator. How I solved "Unable to access HASP SRM Run-time Environment? (H0033)"įirst of all, don’t stress! These instructions will most likely get you up and running with your 4D, 5D, 6D or other dongle-controlled program in short order.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |